30-3000 Micron Johnson V Wire Filter Tube, Low Carbon Galvanized
Wedge Wire Screen Pipe
stainless steel vee sharped wire / wrap wire, johnson screeen,
water well screen / rod based wire wrapped screen, wedge wire
screen, reverse wedge wire screen, stainess steel strainer pipe, v
wire slot tube, perfect roundness well screen pipe, dewatering well
screen, dewatering screen panel, wedge wire grating, v wire flat
panel, screen nozzle, water and gas strainer nozzle, stainless
steel filter nozzle, wedge wire support grids, sieve bend plate, v
wire screens, ARC screen, filter bottom nozzle, stainless steel
lateral screens, wedge wire filter candles, Rotary drum screens,
strainer cylinder, sand control well screen, oil well screen, rod
basedc ontinuous slot screens, header and hub laterals & hub radial
laterals etc.
Product Quick Details:
1. 30-3000 Micron Johnson V Wire Filter Tube, Low Carbon Galvanized
Wedge Wire Screen Pipe
2. Selling point: High Strength, Easy Installation, Anti-Pressure,
Rust resistant
3. Surface treatment: Galvanized
4. Well deep: v / wedge wire: 2.5x4mm Well deep: 200-300m,
v / wedge wire: 3x4.6mm Well deep: 350-450m
v / wedge wire: 3.0x6mm Well deep: 500-650m
5. Flow type: From outside to inside (FOTI), from inside to
outside(FITO)
6. Production process: Galvanized after full welded
5. Package:
Plastic bubble bag packaging
Transparent plastic bag inside, woven bag outside
Wooden box
Pallet
Features of Johnson Wedge Wire Screen pipe:
1. Screens with high open area are more suitable for the
construction of high-quality water wells, oil wells and gas wells.
2. Low cost operation
Screens with high open area shall favor groundwater infiltration.
Abundant water shall reduce the water level’s down, thus to save
energy consumption.
3. Reduce the abrasion of the pump
Under the same condition, high open area can make the speed of
groundwater's entering into the screen much slower than any other
filtration apparatus, which will avoid sand’s entering into screen
because of high pressure, thus reduce the abrasion of the pump.
4. Extend the life span of wells
Comparatively, groundwater's entering into screen with higher open
area is much easier than the entering into lower open area screen.
The slow water flow shall extend the life span of wells.
Each case is clearly marked with:
Material: LCG Water Well Screen
Slot: 1.0mm, or customized
Diameter: 2", 3", 4" , 6", 8", 10", 12",
Or customized
Regular Specification:
| Wedge Wire Johnson Well Screen Pipe |
| Specification (Profile wire): | Width(mm): 1.0 1.5 1.8 2.0 2.2 2.5 3.0 3.2 etc.
Height(mm): 2.0 2.5 3.0 3.5 4.6 5.0 6.0 etc. |
| Specification (support rods) | Width(mm): 1.8 2.0 2.3 2.5 3.0
Height(mm): 2.5 3.0 3.5 4.0 4.6 5.0 6.0
Round: From ø2.5mm to 6.0mm round wire |
| Note: other wires and rods available upon request |
| Slot size (mm) | 0.03, 0.05, 0.10, 0.15, 0.20, 0.25, 0.30…… 100mm also achieved upon
request. or 30-3000 micron, or 0.001-0.118" |
| Material | Low carbon wire, Low Carbon Galvanized |
| Length | Upto 6 meters |
| Diameter | 24-1300mm |
| Screen ends | Plain beveled ends, male/female threaded, flange, close up. |
| Other sizes available on request. |
Advantage
| Reduce energy consumption and increase water flow. Reduce erosion of entry surfaces and increase well life. Allow a uniform and efficient well development. Reduce significantly potential pump damage and subsequent
maintenance costs. |
Advantages of Wedge Wire Screen Pipe:
Non-clogging capabilities
Self supporting
High abreaction resistance
Large open area
Better sand filtration
Energy saving
Lowest possible cost
Long using life
Maximum flow capacity
Use:
water well
water supply systems
Refining & petrochemical
Filter equipment
Drum Filter
Sand control
Groundwater
Pump Filter
Motor Filter
Dewatering
Characteristic:
1. Easy to leak, wear and corrosion resistance.
2. The cross section of the mesh is trapezoidal. The gap is narrow
at the top and wide at the bottom.
3. It is a screen bar made of cold-rolled stainless steel wire. The
support bar is welded by automatic mine screen production
equipment. The screen seam is uniform, the welding quality is
stable, the opening rate is high, the service life is long, and the
strength is high. Rigidity and bearing capacity can be made into
rigid screening and filtering devices of various shapes.
OEM service:
We can produce products according to the needs of our customers.
Material: stainless steel 304, 316L, low carbon steel
Diameter: minimum diameter 32mm, maximum diameter 1270mm
Length: single tube can be up to 6 meters in length
Gap: 0.25mm, 0.5mm, 0.7mm, 1.0mm, 1.5mm is a regular gap. We can
produce gaps of 0.1-50mm
Joints: Generally, there are joints at both ends of the pipe, such
as flanges, weld rings, or threads, so that the pipes can be
connected to meet
---------------------------------------------------------------------------------------------------------------
FAQ
Q1. Can I have a sample order?
A: Yes, we welcome sample order to test and check quality. Mixed
samples are acceptable.
Q2. What about the lead time?
A: 3-5 days for Sample preparing , 15-25 working days for mass
production.
Q3. Do you have any MOQ limit for the order?
A: Low MOQ, 3pc for sample checking is available.
Q4. How do you ship the goods and how long does it take to arrive?
A: Airline, sea shipping and rail transportation are all optional.
Or ship by EMS, DHL, UPS, FedEx or TNT, it takes 5-7 days to
arrive.
Q5. How to proceed an order?
A: Firstly let us know your need specification or application.
Secondly We quote according to your requirements or our
suggestions.
Thirdly customer confirms and places deposit for formal order.
Fourthly We arrange the production.
Q6. Is it OK to print my logo on the product?
A: Yes. Please inform us formally before our production.
